FX LINERS (AGAIN)!
- Thread starter Spray1Mark
- Start date
G
Guest
Guest
new friendly answer from FX Service
”
Yes sir, the factory is getting an engraving machine in order to label each liner, but has not obtained the machine yet. For now, you have to trace the twist rate that is observable from the exterior of the liner. The Pellet Liner A is 1:30", the slug liner should be close to 1:22". You can also tell by measuring the choke of the muzzle end of the liner. The choke on the Pellet Liner is 0.02", where as the Slug liner should be 0.06".
”
Yes sir, the factory is getting an engraving machine in order to label each liner, but has not obtained the machine yet. For now, you have to trace the twist rate that is observable from the exterior of the liner. The Pellet Liner A is 1:30", the slug liner should be close to 1:22". You can also tell by measuring the choke of the muzzle end of the liner. The choke on the Pellet Liner is 0.02", where as the Slug liner should be 0.06".
Upvote 0
It seems that few know what FX is actually doing? thanks to Matt for his input, he has more knowledge than anyone as far as FX goes.
Perhaps FX have been pressured into doing this by public demand? the roll out of such an exciting product should have been handled better!
Personally I can't wait for my the Daystate slug offering now LOL!
Perhaps FX have been pressured into doing this by public demand? the roll out of such an exciting product should have been handled better!
Personally I can't wait for my the Daystate slug offering now LOL!
Upvote 0
The guys at Airfective did some work and cut the choke off the slug liner, it appears that the velocity went up and accuraccy didn't suffer!
Upvote 0
I had such a thought.
I will produce the results of the slug tutorials that will get.
need to buy a 600mm barrel and cut it up to 500mm.
I will produce the results of the slug tutorials that will get.
need to buy a 600mm barrel and cut it up to 500mm.
Upvote 0