This rifle takes a couple minutes to get back to the set pressure or even get close to the set pressure. I bought a Huma reg and it helped a little bit. Is there a screw too tight somewhere restricting air to the regulator I can check?
FX FX Panthera slow recharge rate.
- Thread starter 4640saba
- Start date
The screw is in your head, labeled patience. The delrin disc on the reg needs time to settle (compress) such that it works as an on/off switch, rather than a potentiometer.
Upvote 0
You might try degas your rifle.
Unscrew the regulator. Look at the little holes in the large brass section. I had a couple of them that had burrs from the machining process. After I cleaned them out with cutting torch tip cleaners it recovered much better.
Your head is fine!
Upvote 0
It’s weird that two separate regulators are doing the same thing. I’ll try that. What does the brass screw do that is above the front brass plug for a front bottle adapter?
Upvote 0
If you pull the regulator go ahead and spend the time to polish your Beeville washers. There is a great post on how to polish your regulator that I followed for both my Crown and Dynamic
Upvote 0
