FX FX Power Wheel Rotation!

[moreplease]

Hi,
About the FX PANTHERA macro power adjuster wheel.
I wonder is this designed to be rotated both ways clockwise /anti-clockwise ?
What's the correct recommend official method to rotate it as I feel like it's stuck at 23 no matter I set it to low numbers

 

[Sharp Pog]

try slightly loosening the allen screw that holds the wheel on

 

[rc4fun]

Are you saying the wheel is stuck or that the power stays the same? It should rotate both ways stopping at the lowest and highest setting.

 

[moreplease]

It rotates as normal but I do feel the power is really high no matter what I set it to low numbers.
The weird thing is that I noticed when I uninstalled the tank I shoot one or two shots to bleed the plenum while back in the days I was shooting at least 6 shots to empty the plenum at the same settings
Reg at about 115bar and power wheel on 19.
So the fault in the plenum or the reg or what!!!

Are you saying the wheel is stuck or that the power stays the same? It should rotate both ways stopping at the lowest and highest setting.

 

[Trucker3573]

If you are seeing no power change with the macro it sounds like the micro is set way too high for the reg pressure

 

[moreplease]

If you are seeing no power change with the macro it sounds like the micro is set way too high for the reg pressure

I found out the problem,
When I remove the tank I noticed the plenum bleeds after 1 or 2 shots only compared to 6-8 shots before that error.
So what's wrong that makes the whole plenum air goes out in one single shot ?
Is the plenum valve is not working or the hammer hit so hard for some reason?
I'm new to all of this.

 

[rc4fun]

Put the power wheel on 5 or 6 and set the micro to 2 and see if that changes anything.
You should note what caliber and what you are shooting. Perhaps a search for FX PANTHERA tune.

 

[rc4fun]

Changing the power wheel and micro should be done with the gun uncocked.

 

[Trucker3573]

Possibly the micro adjuster got turned up accidentally? I would do what rc suggested and see if that helps.

 

[moreplease]

Changing the power wheel and micro should be done with the gun uncocked.

Yeah I read that on the manual before I started using the gun, I used the settings you suggested, still I have the same problem, the whole air in the 62cc plenum is released in a single shot which is not normal.
At 115bar and low hammer settings the plenum should give at least 5-6 shots.
What might cause such plenum over releasing?!

 

[18.13]

Should take 1 or 2 shots is normal

 

[rc4fun]

Don't worry so much about the plenum without the tank attached. What are you shooting and how fast are they going?
You may very well have a problem connect with your dealer and see what they have to say.

 

[moreplease]

Problem is at 115 bar I don't feel there's a difference at velocities between power wheel on the lowest or mid or max
At 13.5g light weight pellets.
Which is not what I think is default or normal.

 

[Revoman]

A chronograph will prove out your suspicion on the velocity.

mike

 

[moreplease]

It did, that's why I decided to post the problem here.

 

[JohanG]

I would say up the pellet weights to 25 grain. Maybe the light pellets does not react to the changes in the settings that well.