GMI slug . accuracy and data

[jwrabbit123]

SOON IWILL TEST RATTLER IN 30 WHEN I GOT THE 30 RATTLER I THOUGHT BORE SIZE WAS BORE WAS ,300 LIKE MY EVOL I SOLD AND MY R5 30 EDGUN I SOLG BUT GUN JAMMER WITH THEM WHEN I MEASURED BORE IT IS ,294 , SO I DID ORDER A BUSHING FROM NOE IN 297 AND 298 AND MADE SOME BOTH THESE SIZES TO TEST

 

[jwrabbit123]

i got a chance again to try 25 caliber slugs in a epic 2 weather was 15mph 18 degrees temp this gun is new to me , I shot 41 grain GMI slugs ,250 diameter and I also had some AVS ,,254 slugs here is groups
I did not have avs target must of gotten deleted . this group is the gmi group ,,,again it was not best conditions you can see group was from wind but when it was same mph alot of double holes and I had a lower quality scope and not to make excuses lol but I had onlt had one sand bag under front of gun and in rear I used my hand to hold it up so not the steadest way to shoot a group , so I know with 2 bags or a sock with sand can do better the speed was around 900fos also and with maverick it had shot better in the 950ish area

 

[Revoman]

You sure seem to have the slug making process down. The recent groups that you have shown are pretty dang good at 100 yards.
Keep up the good work and showing how it's done.

mike

 

[jwrabbit123]

coming next 30 cal

 

[jwrabbit123]

here is 25 epic 2 100 yards with 40 gr and 48 grain 920 to 950fps

 

[jwrabbit123]

here is my Mk2 impact shooting 30 grain ,218 slugs 950fps , this isw with a 700 mm new slug liner 100 yards , it was a bit windy I was sitting down off my tripod with a 4x20 zco scope at 12x

 

[jwrabbit123]

here is rattler 30 before I worked on gun the way I got gun from aoa
before

Here is after I redid barrel and took gun apart and fixed regulator and jamming , and recrowned and polish barrel .