Going too good

[Hateful McNasty]

Took this down to clean and relube and putting it back together man it was going too smooth. Keepers just popped right in trigger, safety and the 2 pins just dropped in to place i mean smooth and easy as ever ......

Well right up till i went to put the barrel back on and seen why it went yhat far easy and trouble free..

That oops bonehead moment..lol

Well i guess nothing like rework after you think your shining.. man..

 

[Uglyjohn]

Whenever I work on one of my springers, the job usually ends with these 3 steps: take it apart, do it over, do it right. Uj

 

[Hateful McNasty]

Whenever I work on one of my springers, the job usually ends with these 3 steps: take it apart, do it over, do it right. Uj

Ya, i was just going at a la de ,la de ,la pace. You know that smooth sailing...

Thing was how i had to be looking at it and never noticed. I guess i got eyes but cant see...lol

 

[Hateful McNasty]

I guess not too bad in another 1/2 tin or so ill crony it and see. What i also been doing is taken mg off a bit of seal to see if i can make a better fit/performance. This arh spring and seals been kinda " funny" i guess

Anyway first shots after quick resighting at 50y.

 

[beerthief]

never taken a springer apart yet............. yet !

 

[Hateful McNasty]

never taken a springer apart yet............. yet !

Well this hw/r9 the spring broke in like 4 months of use.. then with that the seal was spiderweb cracked and cracked completely through. Also hard as a rock.

Personly im finding a guy best served when new to take it down and see what he got in the factory work . Been pretty sloppy more then just right.

 

[Hateful McNasty]

Well end results at 50 rebteakin today
Oh well.... Can't say if the out low ones were me or gun. Im blaming the gun cause it's never the shooter, right?

On stock irons.

 

[45srbest]

Looks good to me! We know guns love to throw flyers!

 

[SpiralGroove]

Well this hw/r9 the spring broke in like 4 months of use.. then with that the seal was spiderweb cracked and cracked completely through. Also hard as a rock.

Personally I'm finding a guy best served when new to take it down and see what he got in the factory work . Been pretty sloppy more then just right.

I've taken apart and tuned every gun I've owned. First thing I do is scrub the barrel and shoot it.
If accuracy is good, I immediately take it apart and give it a full tune. I then create the power level, shot cycle balance and tune the trigger.
- The gun then becomes everything I want it to be ... plus I enjoy the mechanical work