GX-E-CS3-1 Compressor Parts?

[Jake W.]

I am new to the forum and navigating a little slow. This question may have been posted, but I do not find it.........I need parts for my GX-E-CS3-1 compressor, but do not find the part that I am looking for. I have been purchasing some replacement parts form Target Forge and Mr Ruehl is a great source of information for the GX compressors in general, but he doesn't list all parts for my unit. I am actually needing a replacement switch that is located on the front bottom of my compressor. I have found some from other suppliers, but the dimensions are different and would require that I modify the cabinet. I would greatly appreciate any input concerning this.
The customer support for these chinese compressors seems to be hard to find.
Thanks!
J.

 

[bchannell]

can you post a pic of the switch. If you're talking about the switch that is the circuit breaker, then it is available on Amazon and from GX directly.
If you look here, the video has the part number you need.
Here's the link to the GX site

GX Pump PCP Air Compressor | GX CS4 Air Gun Compressors 2023

GX CS4 Portable PCP Air Compressor, 350W Powerful Motor,Max 5800Psi/40Mpa, Water and Fans Cooling, 5 Hours Continous Work, 12V Auto Stop，for PCP Air Rifle Paintball

gxpumpofficial.com

 

[Jake W.]

I have the GX-E-CS3-1 compressor and this switch is a boat rocker toggle switch according to the internet.
J.

 

[bchannell]

Give GX a call and they can help you out.

 

[Jake W.]

Thanks for all the advice…… I did connect with them and my part is on the way.
J.

 

[Baddoglowder]

GS compressors have a website and messaging , or phone - they will get back to you but China is on a different time zone which will be a factor plus English not being their 1st language.
I’ve asked several questions and actually got answers though sometimes hard to understand them .
Goid luck with your unit - I’m into them fines two and rebuilt tye 1st one top to botto with target forges help . Their instructions are close but there are a few tricks not shown well in print … also there is/was a Facebook page with a fellow who knew the ins and out throughly … he knew tye tricks I overlooked in the head assembly . It only works one way but will go both ways assembled causing one to pull their hair out .

 

[Jake W.]

Thanks to everyone for the input......there is a lot of accumulated knowledge available on this web site and I appreciate your willingness to share it.
J.

 

[Jake W.]

also there is/was a Facebook page with a fellow who knew the ins and out thoroughly … he knew the tricks I overlooked in the head assembly . It only works one way but will go both ways assembled causing one to pull their hair out .

Hey Baddoglowder,
Your post caught my eye concerning the head assembly going together two ways, but with only one way working? I do not have facebook access and was wondering if you can share anymore tips on the head assembly?
I have replaced everything that is possible and still have no pressure in my GX-E-CS3-1 compressor.
Thx!
J.