Hatsan Blitz 30cal troubleshooting bolt fails to rechamber next pellet, low fps,
also have to manually pull back bolt to fire,
also have to manually pull back bolt to fire,
Hatsan Blitz Troubleshooting
- Thread starter KindaQuik808
- Start date
I dunno. Some people have trouble with the Blitz, others, like myself, not so. I do give mine a quick squirt of WD-40, or Tri-flow down the barrel opening, once in awhile, to help keep the "piston" lubricated. How old is yours? how many rounds have you shot? What pellets/slugs?
Upvote 0
Worked fine on tuesday, then yesterday the bolt would not cycle it moved a little, decided to empty air and refill after doing so the bolt just stays forward, or moves just enough where air starts leaking but stops if i push the bolt forward
Upvote 0
What did you end up doing to fix this issue? I am having the exact same issue and fighting to get the problem resolved.
Upvote 0
Under rifle near filler gauge had been missing 2 hex bolts. You can purchase the bolts from a hardware store.
Upvote 0
I had lots of problems with my Blitz. No accuracy what so ever, about a 1 yard spread at 100 yards.
If I remove the stock and fire the rifle the hammer spring screw will rotate and become loser and loser.
I had cycling problems as well, the bolt was hitting the plastic inside the magazines, so either the hammer was too fast or magazine spring too slow.
I increased the spring tension by half a revolution. The gun was greased with some white thick gunk, removed it any used gun lubricant instead.
After this the rifle worked fine, but I need to figure out why the hammer spring screw is coming undone when firing, this might fix accuracy problem.
If I remove the stock and fire the rifle the hammer spring screw will rotate and become loser and loser.
I had cycling problems as well, the bolt was hitting the plastic inside the magazines, so either the hammer was too fast or magazine spring too slow.
I increased the spring tension by half a revolution. The gun was greased with some white thick gunk, removed it any used gun lubricant instead.
After this the rifle worked fine, but I need to figure out why the hammer spring screw is coming undone when firing, this might fix accuracy problem.
Upvote 0