anyone know the size of o rings for barrel and pellet probe for a 25 cal? hatsan is out of stock on the repair kits for 25 cal .can't shoot it till I find them . try plumbing o rings but just couldn't find any the right size they were all to thick
hatsan flash o rings
- Thread starter karterguy
- Start date
I figured it out. they go by cross section by inside diameter then type and hardness. the o ring store has every metric size available cheap u just have to buy 20 min of each. I will be ordering some if anyone needs any?
Upvote 0
Good info. I have the .22 and just replaced the pellet probe. I'm hoping this fixes my feed issue where pellets were constantly jamming. The gun came with a kit with a bunch of them. Did you go through yours or did you lose the kit?
I wished I had the .25 the other day. Freaking pellet bounced off a big iguana's head.
I wished I had the .25 the other day. Freaking pellet bounced off a big iguana's head.
Upvote 0
I never had the o ring kit.. i decided to tune the gun and open all the ports and install a reg and and regrown and polish the barrel. saw some pouring dam when doing all that. I just ordered a bunch online there only a nickle ea lol . just had to fund out how to properly measure o rings. I would def want a 25 on iguanas there tough critters. I'm supposed to be in south Florida right now on vacation but damn trannybwent out in my truck 3 days before we were supposed to leave so I had to push it till the end of Sept for the kids fall break. can't wait to shoot some iguanas.
Upvote 0
The .25, in most instances, would be, ahem, overkill. It's really just a very few shots that deflect off if my placement isn't perfect. I worried that the .25 would use more air and that's an issue for me, since I don't have a compressor. For the most part, the .22 puts em down, even from a distance.
Come on down when the weather isn't so freaking brutal. Hit me up, I'll put iguana in your crosshairs.
Come on down when the weather isn't so freaking brutal. Hit me up, I'll put iguana in your crosshairs.
Upvote 0
I need to get some spares for a .22. got a tin of pile drivers to try them out and they promptly ruined mine. Tight fit snagged ring and tore it.
Haven't measured it yet but I'm assuming they're metric since I couldn't find an exact match even from a pretty good selection at a hardware store that were all inch based. Real close but not quite.
Haven't measured it yet but I'm assuming they're metric since I couldn't find an exact match even from a pretty good selection at a hardware store that were all inch based. Real close but not quite.
Upvote 0
u need some digital calipers really. first it's the thickness of the o ring they call it cross section.then it's the inside diameter.i got mine from the o ring store .look at the mm o rings the the type which I went with the common buna n70
Upvote 0
Givethemlead I just got a Hatsan flash in 22 with the wood stock and my bolt is jamming bad with the single tray and the magazines ,when im pushing forward I have to down ward on the bolt which makes me mad .
Upvote 0
Check that the o-ring is in place in the breech, just forward of where the front of the magazine seats. Mine was gone. Once replaced it was all good.
Upvote 0