Just received a Wildcat and installed dual transfer port and Huma regulator with power plenum. Having issue with getting cocking handle adjusted so rifle will cock. Need suggestions. Thanks
Tuning Help with Wildcat .30 cocking handle adjustment
- Thread starter arizonapcp
- Start date
What he said is probably right. Otherwise, it would be as simple as loosening the screws where the side lever linkage connects to the cocking rod, and re-tightening them in the proper position. If you try and adjust it where the probe seats too deep, you'll also have issues cocking the gun and closing the bolt. I hope that helps.Upvote 0
If you loosened the air tube/barrel clamps in the process and didn't get the air tube clamp in relation to the air tube back in the exact same position it'll change the whole timing of the cocking/trigger and probe depth. Could be what's going on. My original WC gave me fits at one time till I figured out what was going on. If this happens to be the issue and when you get it straightened out be sure to document multiple good measurements and mark the air tube with a fine pencil where the airtube clamps tighten down.
Jking
Jking
Upvote 0