Huma inline regulator problem

[dallin]

I put a pressuregauge on my airtank this morning.

when I was about to bleed the hose. It bled for 2 seconds and then it stopped instantly. Sounded like something blocked the bleeding hole.

the pressure gauge indicates that there is about 230bar on the filling line. 

So my question is how do I bleed the pressure?

anyone who has experienced the same?

hope for a quick answer

thank you

 

[sonny]

might gently slowly open a connection/fitting

 

[Spray1Mark]

Has it stopped at the regulator set pressure? can you still rotate the regulator body?

 

[dallin]

I can rotate the regulator but not at easily as when not pressurized.

anyway problem solved

knife + hose = hose with a hole in it haha

 

[Spray1Mark]

Do you have an endless supply of hoses? or have you actually worked out what went wrong?

 

[willy]

Turn the brass bleed vale on the bottom lower right hand corner counter clock wise slowly,then back out the gauge a little.

 

[dallin]

I can make the hose at my workplace  

and no I didn’t find out anything.

when I pressurized it again it worked fine.

don’t know what happened