I have a Huma mod50 with a loose object in the muzzle end piece! The object is large enough that it wont fit through the muzzle end hole. Anyone know how to open this muzzle end piece so I can remove the object.
Huma Mod50 - muzzle end baffle
- Thread starter mlayton60564
- Start date
i assume you have tried to shake it out ? have you determined if it is metal or a chip off the gun ?
Upvote 0
Yes tried to shake it out but it’s larger the muzzle exit hole. It’s a hard plastic round little insert with a hole through the middle. The moderator is a .30, but I believe the insert was used to reduce the size of the muzzle exit hole to shoot .22 projectiles….
Upvote 0
Anyone? I’m sure someone out there has figured out how to open the muzzle end piece of a Huma moderator?
Upvote 0
I have Mod 40's, and the cap just screws off. It is thin, and hard to get a good grip on, but can be done. I'd suggest using a rubber grip like for opening jar lids, and press the muzzle end into it and twist to get it off.
But that is with the Mod 40 - I have no experience with the Mod 50, but would not be surprised if it was the same but just scaled up . . . .
But that is with the Mod 40 - I have no experience with the Mod 50, but would not be surprised if it was the same but just scaled up . . . .
Upvote 0
What Alan (above) said.
I know that both the Mod 30 and 40 have the screw on end cap as noted. I'd...assume, that the Mod 50 would be the same design.
Mike
I know that both the Mod 30 and 40 have the screw on end cap as noted. I'd...assume, that the Mod 50 would be the same design.
Mike
Upvote 0
Thanks guys! I will give that a try! I’m sure the Mod50 would be no different than the mod30 or mod40….
Upvote 0