HW/Weihrauch HW 35e 11mm to Picatinny solution from Warne

[Jaxjax]

I ordered this Warne rail a while back for another project & that one needs a 3/8" solution from measuring so I used this Warne CZ rail for my 35e. Angles seemed correct & went at it as this is a 1 piece rail & you have to tap it on as tight fit. I used small oak block & soft blow. small ball peen woulda even worked better with the block. It's not a forced issue as it moves forward each small tap. I don't like to be pigeon holed with rings so I like to adapt to 1913 if possible. I dought mount will move. There made from 7075 t-6 & nicely machined without sharp edges. Just thought to show another 11mm solution. Warne also has another 11 CZ rail thats slightly differant that would work also.
Joe

 

[JDR]

Like the looks of that mount. Warne makes good heavy duty stuff.

 

[Mycapt65]

Wow that's great solution for a lot of airguns. Well as long it doesn't slide. I'm sure a recoil pin could be added if it does

 

[marflow 777]

nice droop rail

 

[Mycapt65]

How long is that rail? With the additional height it adds I'd prefer low rings. With similar setups on powder burners the rail hit the objective bell. I either had to use taller rings or cut back the front end of the pic rail to get proper eye relief

 

[Jaxjax]

How long is that rail? With the additional height it adds I'd prefer low rings. With similar setups on powder burners the rail hit the objective bell. I either had to use taller rings or cut back the front end of the pic rail to get proper eye relief

I'll measure when I get a chance. There is also a 7757M that appears longer but no spec on length that I can see. They unfortunately do not make aa 3/8 version for the CZ 452 american crowd. That leaves EGW for 3/8 & a few others.

 

[Mycapt65]

I'll measure when I get a chance. There is also a 7757M that appears longer but no spec on length that I can see. They unfortunately do not make aa 3/8 version for the CZ 452 american crowd. That leaves EGW for 3/8 & a few others.

Thanks.