Beeman HW90 Trigger Unit Disassembly

[Bad News Beeman]

Hey all. I recently picked up a RX1 whose safety was not setting when cocked. Upon taking the action out of the stock, it became clear that back half of the trigger sear had sheared.

Looks like spares are available, but what resources are out there for how to take apart the trigger unit to swap out the part? Plenty of tutorials exist on the regular Rekord, but I haven't seen much on the hybrid version in the RX1/HW90.

 

[Airman-of-the-Board]

You may be able to learn some things about the HW90 trigger unit by watching the following videos. Good luck.

 

[jarmstrong]

this video is just what I been needing, My Rx is needing to have a reseal as the gas cylinder is leaking. I have been avoiding fixing it because I dislike the stock trigger,,, it sucks. I see now I need to play with a replacement spring and this video shows me the way forward.
I brought a new scope for it a cheapie Centerpoint because I see in the reviews the centerpoint can take a lickin and keep on working, mounted it up and found it has a bent barrel that needs some attention. Now I have 3 things on it to fix,,, trigger, seal and bent barrel,, and crap,, spring has sprung and I have too many other things that need done now,,, so it will wait till the heat of the summer, to be worked on, but now I have a plan to make this gun shine
Yes, she is a 20 cal gal

 

[scottc]

Before buying my used .25 HW90, I studied these 2 vidz. Believed I could swap springs if needed. I love my unit's trigger because In the USA powder burners are often single stage triggers usually over 5 pounds from the factory for hunting. I call the HW90 Elite trigger a great single stage trigger, that breaks very consistently at a guesstimate +/-3 pounds. It will be a minor tinker to get another half pound with a spring if I am ever inclined.