FX Impact Leak at angled manometer mounting location

[Broozer]

Hi,
I found a tiny leak coming out of the hole where the wrench is inserted. I found the leak out of pure luck. I placed a piece of tape on the vent hole, thinking that it was the source of the leak and found the leak right next to the vent hole. After I degassed the gun, I removed the screw with little resistance. The grub screw threads were clean. No sign of sealant.
Anyways, is blue loctite recommended or is there anything else better.

Thank you,
Gabe

 

[Impact701]

Hi,
I found a tiny leak coming out of the hole where the wrench is inserted. I found the leak out of pure luck. I placed a piece of tape on the vent hole, thinking that it was the source of the leak and found the leak right next to the vent hole. After I degassed the gun, I removed the screw with little resistance. The grub screw threads were clean. No sign of sealant.
Anyways, is blue loctite recommended or is there anything else better.

Thank you,
Gabe

View attachment 516740

Utah Air told me to put a small piece of o-ring in the hole before the grub screw.
This sealed it for me .

 

[Broozer]

I went ahead and used some blue loctite after doing some research here.

If that don’t work, then I’ll try the oring piece.

If that don’t work, I guess I may need one of those angled manometers that should have come with the rifle from the factory in the first place iykwim

thanks
Gabe