While shooting my MK2 .30 yesterday these two screws fell out. I can not find where they came from on the parts diagram or any empty spots. Does anyone have an idea? Gun has over 1000 shots through it and I took one additional shot after the last screw fell out which didn't seem to affect the gun.
Tuning Impact MK2 help....
- Thread starter WVCondor
- Start date
Looks like
But if gun is working without any issues maybe some extra got stuck somewhere when they assembly the gun?
B
Upvote 0
do you have fx no limit scope rings? might want to see if that is where they came from. Id have to pull one of mine to verify, but i did notice that both of mine were backing out a few weeks ago and they seem to be travel stop pins for them...
Upvote 0
If you flip your impact so the scope is down and the bottle is on top. Then look at the bottom area of the scope rings where the clamp onto the rail. You should see holes on one side on the bases. The holes run from the bottom of the scope rings, straight down towards the inner adjustable section of the ring.
Upvote 0
some pics to help with this issue. the grub screws the OP asked about are the FX no limit picatinny mount adjusters.
this pic shows the location of them in the scope mounts. they are the ones sticking out in the pic at the bottom of the scope mounts. they are also 1.5mm grub screws.
also the Picatinny mounts in the fx no limit line are the only ones that have this adjustment screw.
this pic shows the location of them in the scope mounts. they are the ones sticking out in the pic at the bottom of the scope mounts. they are also 1.5mm grub screws.
also the Picatinny mounts in the fx no limit line are the only ones that have this adjustment screw.
Upvote 0
No problem glad to help as mine also just about came out as well. that was why I knew about them..
Upvote 0