So far I'm not that disappointed in it - I'll do some more testing tomorrow but ran a few mags through it and not bad.
Cycling is smoother than I thought it would be - I was expecting your typical AEA crap quality, it's not refined but it's not their usual crap either.
Magazines are the typical AEA Plastic pieces of shyte. my 308gr slugs are 0.75" and it pretty much maxes out the depth - so I'm thinking max depth to be 19mm or 20mm max.
************* This is unfortunate - magazine unseats sometimes while pumping - so while trying to cycle the next round, magazine pops out and you can't rack it forward. Happened a couple times now. Will see if this keeps happening.
***** Finding #2 - looks like the stupid Fin on the "buttplate" is now loose after 6 mags. There is literally no space in there to fit ANY kind of hex wrench - a hex BIT barely and i mean barely fits in there.
15" .45 Megalodon -
I only filled to 3,000 PSI, so 8 shots brought me down from 3k to 2k. 308gr slugs
Cycling is smoother than I thought it would be - I was expecting your typical AEA crap quality, it's not refined but it's not their usual crap either.
Magazines are the typical AEA Plastic pieces of shyte. my 308gr slugs are 0.75" and it pretty much maxes out the depth - so I'm thinking max depth to be 19mm or 20mm max.
************* This is unfortunate - magazine unseats sometimes while pumping - so while trying to cycle the next round, magazine pops out and you can't rack it forward. Happened a couple times now. Will see if this keeps happening.
***** Finding #2 - looks like the stupid Fin on the "buttplate" is now loose after 6 mags. There is literally no space in there to fit ANY kind of hex wrench - a hex BIT barely and i mean barely fits in there.
15" .45 Megalodon -
I only filled to 3,000 PSI, so 8 shots brought me down from 3k to 2k. 308gr slugs
Last edited: