jet 1 to jet 2 duel air cylinder conversion question

[500red]

hello new to pcp guns bought this jet 1 for close range plinking 20-25yds
i recently bought the duel air cylinder conversion
assembling it now and no where does it say how tight to tighten the 2 set screws that hold the nipple into the body of the gun (regulator)?
thanks for any info

 

[FLgunner]

There are no torque specs that I know of, if that's what you are looking for. When I did the swap on my I just tightened those grub screws down till they were good and tight. The Jet 1 & 2 are not regulated, the valve assembly is what is being inserted into the block.

 

[500red]

There are no torque specs that I know of, if that's what you are looking for. When I did the swap on my I just tightened those grub screws down till they were good and tight. The Jet 1 & 2 are not regulated, the valve assembly is what is being inserted into the block.

ok that's all i needed to hear, i wasn't sure and didn't want to distort anything from going to tight I'm new to these air guns so id rather ask thanks for the info.