Kral Knight project wrapped up

[SteveKralsAround]

Finished another project . A Kral Knight in 25 cal . Carbon fiber tension shroud , 580 carbon fiber tank . NP-03 hammer with 28# spring . Ported and blue printed . Athlon 6 - 24 FFP Mrad , DonnyFL Shogun . Average pellet speeds :

Hades at 950 fps

Fx Hybrids at 940 fps

JSB 33.95 at 840 fps

 

[kaylaindy]

Very nice! 

 

[JimNM]

Drop dead gorgeous!

 

[acs]

Wow, that looks great, nice work...!

How does that gun shoulder..?

 

[Rich_B]

Looks good. I like mine. I had Troy lighten up my hammer and went with the twin spring setup. Put a Huma reg on it with extra plenum and it loves the 17gr NSA slugs. 

 

[DARKHORSE1967]

Looks a bit like a Kervan:



http://www.kervanarms.com/

 

[napairgunner]

Wow looks great! I may have to do that to my Knight S one day!. amazing how you can really get the power up on these rifles with a tune.

 

[dodge3500]

That's sweet looking but whats the cost total for the gun and all you have done vs say a fx maverick or impact?

I could be interested if the savings is worth while.

Thanks

 

[SteveKralsAround]

Around a grand ; I like to tinker and customize most all my stuff . That's just me .

 

[dodge3500]

Not bad,do you have plans to put a regulator on it?

 

[SteveKralsAround]

No regulator going on this . Built one simular in 22 cal , the regulators' plenum was too small ,

I'm content without one on this build . Some of mine have regs , most do not , and one tube tank with double regulators .

 

[SteveKralsAround]

Did I mention having caliber change kits for .177 and .22 cal besides the current .25 standing ?

52 ft/lb behind a .17 cal slug , makes me curious .

 

[jbryan820]

Very nice

 

[darylm]

You should put a 700cc bottle on it. I think it would look even better than the 580.