I have a new Puncher Breaker in .25 cal and need a list please of aftermarket parts that will make the rifle more durable.
Tuning Kral Puncher Breaker must haves.
- Thread starter Pelletslinger
- Start date
If it's a new gun all old flaws were corrected. It should be just fine as is with no need aftermarket parts.
Upvote 0
If thammer says it’s good, it’s good. Use that itchy credit card for pellets and a good scope.
Upvote 0
Thank you. Seal failed with less than 150 pellets through it. The seal near the gauge that is. Received o-rings and a valve of some sort from PA. Will give it a shot.
Upvote 0
Lots of lead
Lot and lots of air
Spare o-rings for fill probe
Time and weather to shoot.
You will be good to go.
Lot and lots of air
Spare o-rings for fill probe
Time and weather to shoot.
You will be good to go.
Upvote 0
Yep. Great gun. I have only had to replace the breech o-ring after 500 shots. I recommend to put a drop of ballistol onto that ring after each shooting session, and leave the cocking lever disengaged when storing the gun.
Also, get some risers for your scope rings, and a bubble level to prevent hold cant.. Will make aiming and shooting more comfortable, resp. accurate.
Also, get some risers for your scope rings, and a bubble level to prevent hold cant.. Will make aiming and shooting more comfortable, resp. accurate.
Upvote 0
So I replaced the 2 o-rings at the fill port end. Tried to put air in, pulled the fill probe and air still comes out!!!
Upvote 0
Leak fixed. Attempted to fill gun and I can't get above 1500psi and gauge on my scuba tank reads 2000?
Upvote 0
Did you tighten the pressure gauge on your gun ? I had overtightened the gauge on one of my PCPs and it did not read the pressure accurately anymore.
Another potential root cause may be that a piece of fill probe o ring got into your fill valve, blocking it ...
You may need to dismantle the fill valve, but I would start with the gauge -- put on some teflon tape and tighten gently. See if that solves it, if not dig into the valve.
Another potential root cause may be that a piece of fill probe o ring got into your fill valve, blocking it ...
You may need to dismantle the fill valve, but I would start with the gauge -- put on some teflon tape and tighten gently. See if that solves it, if not dig into the valve.
Upvote 0
Leak is fixed however, gun shows 1300 psi and gauge on scuba tank reads 2000. I tried a hand pump and still didn't work.
Upvote 0
Anyone know where I can get the Valve Body for the puncher breaker silent? Or should i just trash it? I got it for free and the previous owner had drilled out the burst disc for what I have no idea. I believe its beyond repair. I can post a pic if need be. Mahalo
Upvote 0
It can probably still be repaired to hold air but won't have a burst disk any longer. It's not an issue as long as you don't over fill the gun by a lot or often.
Upvote 0