Kral Puncher Pro 500 air fill nipple issue solved

[Hw9720]

For you guys with a Kral Puncher Pro 500 that uses the Kral proprietary larger air fill nipple, I have seen the light.
Found this on Amazon : JUFENG Condor Joint Stainless Steel M10X1 Check Valve 8 mm Male Quick Connector 30Mpa PCP (9.59 $)
This has the male 8mm threads to fit the gun, the fill nipple is the standard quick connect size all other guns use. No more having to dig out a special connecter to fill your gun.

https://www.amazon.com/dp/B073V3BRDJ?psc=1&ref=ppx_yo2ov_dt_b_product_details

tim

 

[JohanG]

I wanted to do the same on my Kral Shadow, but I was concerned about the thread size. Did it screw into the Kral with no threading issues?

 

[Dr. Kralenstein]

Awesome Tim, thanks for sharing! Did you change out the hammer spring on that gun or you still running the HULK force one lol?

 

[Hw9720]

I wanted to do the same on my Kral Shadow, but I was concerned about the thread size. Did it screw into the Kral with no threading issues?

Went it as it should. Smooth thread mate up.
tim

 

[Hw9720]

Awesome Tim, thanks for sharing! Did you change out the hammer spring on that gun or you still running the HULK force one lol?

Have not changed anything yet,
tim