Those do fit a kral. I bought one for a hatsan and it will work in my kral mega fill ports.
Upvote 0
Kral puncher pro 500 filling probe
- Thread starter Bmhunter13
- Start date
Well maybe worth the try. That was under prime instead of just anything amazon. + Less then like pa offer..
Its just a you buy , you try, and hope it dont make ya cry.. when your stuck your stuck..
Upvote 0
The fitting I referenced a couple of posts back was what I found to fit my puncher pro. For reasons no one can explain Kral does not use a foster fitting on their bottle guns. They use a proprietary fitting that also does not use the British standard male thread. The fitting I referenced was found by trial and error. I tried the 1/8" BSS thread and it will not thread into the female thread on the receiver. I think If you forced it you may be sorry for trying. The M10 thread screwed into the hole with no force and bottomed out against the o-ring seal.
Some have mentioned a fill probe but If I am correct Kral does not use a fill probe on any of their bottle guns.
While I didn't have any problems using the original fitting I was worried if it failed I could not get another one.
Some have mentioned a fill probe but If I am correct Kral does not use a fill probe on any of their bottle guns.
While I didn't have any problems using the original fitting I was worried if it failed I could not get another one.
Upvote 0
I would get one of these and you never need an adapter again https://spares.bagnallandkirkwood.c...foster-kral-bottle-rifle-complete-fill-valve/
Upvote 0
