EDgun Leshiy 2 9mm disassembly - need help putting a part back

[airn]

If anyone has access to a Leshiy 2 Workmat, I believe I'm working on the "forward plug" portion of the Leshiy. I attempted to follow Edgun West's Leshiy 2 Indexing Problems video, but an unexpected part (looks like the video wasn't shot for the 9mm) threw me off.

It's the tiny black cap. Where the hell does that thing go? I could really use a schematic or a photo of the forward plug assembly.

 

[Jack.K]

Hope this helps

 

[airn]

Thanks! I completed the disassembly, but it didn't solve my indexing issues. I think I'm going to have to ship it back to Edgun West if I can't figure out what else could be wrong.

 

[PasadenaMike]

Did you receive it like that? They don’t just not index for no reason. Did you disassemble it as soon as you got it ? It’s usually not the internal parts that are the issue normally

Make sure your pellets are seated

Make sure your barrel is in the most front position, loosen grub screws and push the barrel in and tighten grub screws

Make sure you have trigger free play

 

[PasadenaMike]

*****

Kinda inappropriate and disrespectful.

 

[Ievgen721]

Somehow it is that the low-quality products that fell under sanctions and continue to be sold in the USA, having only changed the name and legal address! Is that clear? This is the section on spring pneumatics, what does this garage creativity have to do with it, and especially PСP?The user has 2!!! messages!! He could be anyone.

Kinda inappropriate and disrespectful.

 

[airn]

Nah, disassembly only happened after indexing issues. I'm sending it back - don't want to risk causing damage.

And, yes, I'm new to the forum. Not sure what that has to do with a technical question.

 

[DonEnzone]

Whenever I had indexing issues it was usually the magazine plate that's either bent or scratched. I highly advise trying out at least a few fixes. It helps you to understand the gun better, and prevents having to send it back to EdGun every time a problem occurs.

Does it happen with all the magazines, or just one of them? You could dry fire it (make sure to take out the red transfer port first!) and see if the indexing cog turns or not. If it does, it's most most likely just the mag.

Also check if the barrel alignment. It has to be snug against the receiver block. If it sticks out even just a milimeter it can cause cycling issues.

 

[bckyrdsnpr52]

That little "cap" goes in first under the plunger.

 

[airn]

I tried a few magazines, and it happened with all of them. I ended up paying the $300 and shipping it back to EdGun West. Thanks for all the help - perhaps I should write them and ask what the issue was, so I can be more self-sufficient in the future.