making a .357 and a shotgun make gauss guns

Status
Not open for further replies.
a dump valve in a aps mkII connected to a airforce tank air loads by cocking the pump into the valve in the bolt rigged to dump 11 up airgun shotgun airforce texan power



a umarex legends the hammer cocks the airforce tank .357 ammo goes in the tube shortened the internal space dumps through the hose into the bolt lever action repeating airforce texan



gauss pistols and rifles neodymium magnet wire two automatics and a gauss twice above firearm velocities thats a double ended time rifle i piloted may make it its kinda useless it passes out of phase state at the lower end of the velocity of a projectile or by heat it is extremely dangerous it lodged a screw in my abdomen no entry wound was aimed at a basement wall below ground level acquiescent coating on lead or steel on the projectiles two aimed at eachother but it works



Photo Apr 10, 4 47 28 PM.1619633709.jpg
Photo Apr 10, 4 48 10 PM 1.1619633740.jpg
Photo Apr 10, 4 49 12 PM.1619633690.jpg
Photo Apr 10, 4 47 11 PM 1.1619633773.jpg
Photo Apr 28, 1 46 32 PM.1619633831.png
Photo Apr 28, 1 46 44 PM.1619633914.png
Photo Apr 28, 1 46 41 PM.1619633918.png
Photo Apr 28, 1 46 29 PM.1619633923.png

 
pics later probably three on the lever action 357 weeks six weeks on the shotty the umarex tdp 45 was a one week build the barretta took 600 sig was 300 and the steel storm was 250 is about 840 for the umarex lever .357 and about 848 for the pump action shotty im gonna get some thick ass plexi blast glass and pull the trigger with a caliper on both the builds just in case so i dont get my hands blown off
 
Status
Not open for further replies.