So to my expert regulator peeps..
I've been trying to figure out an issue with the Epic Two for a while with the regulator.
The first problem is gone because I took the Huma regulator out = issue gone. (super duper slow refresh, up t 25 mins by time the reg set pressure was almost reached, and the issue was never resolved.
Issue two:
New epic gen II? regulator brings the pressure up by 1 bar every 10-12 shots until it's about 8 bar over my set pressure and shot string is affected as you can guess. When the airgun is aired up again, a few shots drops the pressure back to the pressure I initially set it to, then does the same thing on the next string moving up, refill few shots repeat repeat repeat.
I've replaced the valve and made sure the this was a 2mm protrusion as the first one was at 3mm likely from the vendor. (so this problem was fixed)
But what is happening is the reg creep as the pressure drops time after time and over a few thousand pellets over the chrono now. Another replacement regulator does the exact same thing. Lower pressure causing higher reg pressure.
I actually give up by myself, and even with epics help and advice. I've tuned exactly the way I was directed and done this from the beginning over and over to no avail.
I'm actually thinking about trying to replace the regulator with some inline bottle regulator if possible if I can't find the issue.
I know two others with the airgun and they don't have the same issue.
Anyone know what can cause lower pressure in bottle causing more pressure in plenum with each shot?
I've been trying to figure out an issue with the Epic Two for a while with the regulator.
The first problem is gone because I took the Huma regulator out = issue gone. (super duper slow refresh, up t 25 mins by time the reg set pressure was almost reached, and the issue was never resolved.
Issue two:
New epic gen II? regulator brings the pressure up by 1 bar every 10-12 shots until it's about 8 bar over my set pressure and shot string is affected as you can guess. When the airgun is aired up again, a few shots drops the pressure back to the pressure I initially set it to, then does the same thing on the next string moving up, refill few shots repeat repeat repeat.
I've replaced the valve and made sure the this was a 2mm protrusion as the first one was at 3mm likely from the vendor. (so this problem was fixed)
But what is happening is the reg creep as the pressure drops time after time and over a few thousand pellets over the chrono now. Another replacement regulator does the exact same thing. Lower pressure causing higher reg pressure.
I actually give up by myself, and even with epics help and advice. I've tuned exactly the way I was directed and done this from the beginning over and over to no avail.
I'm actually thinking about trying to replace the regulator with some inline bottle regulator if possible if I can't find the issue.
I know two others with the airgun and they don't have the same issue.
Anyone know what can cause lower pressure in bottle causing more pressure in plenum with each shot?
Last edited: