Diana More ?s on Diana Stormrider Gen3- regulated

[dlancerx]

So, I finally decided to disassemble my Diana Stormrider to see if I could tinker with the regulator to get a little bit more accuracy. As shown in the pic, factory setting is where I've marked with black. Since there are no indicators to tell at what pressure/bar it is set at, how many turns do you think would be needed to raise or decrease the pressure/bar?

Thanks in advance.

Note: I've already drilled the transfer port to a 2.5mm size hole.

 

[wildcj5]

I don’t have a SR but not much. I would do 1/8 turn and see what it gets you.

You mentioned doing this for accuracy. Have you done any barrel work? Adjusting speed has an effect but if you are fighting a burr on the transfer port or crown nothing is going to change other than the speed.

 

[dlancerx]

I don’t have a SR but not much. I would do 1/8 turn and see what it gets you.

You mentioned doing this for accuracy. Have you done any barrel work? Adjusting speed has an effect but if you are fighting a burr on the transfer port or crown nothing is going to change other than the speed.

Thank you