Is that normal? I want to be sure I am setting it up right,oil,water ,whatever....what is the procedure? Thank you.
My Yong Heng did not come with insructions.
- Thread starter boscoebrea
- Start date
Theres so much info on here and YouTube about them shouldn't be too hard to find.
"setting up yong heng compressor" into the YouTube search brings up dozens of applicable videos.
Use this oil IMO
"setting up yong heng compressor" into the YouTube search brings up dozens of applicable videos.
Use this oil IMO
Upvote 0
This is all I’ve used in my yong Heng going on two years still runs like new. Just keep it clean , 
Upvote 0
Never fire up the compressor under back pressure load. Always use an electrical outlet with more than comfortable enough juice preferably off of a dedicated circuit. Proper oil and break in procedures as well as maintenance helps make things last as well as not filling to max pressure which is the major compressor killer unless you like to rebuild things then no problem.
Even If you have the 4 year warranty you might still want to reconsider filling to the max pressure (OR NOT!). Get a good filter too.
Even If you have the 4 year warranty you might still want to reconsider filling to the max pressure (OR NOT!). Get a good filter too.
Upvote 0
Here is a little more info for to help you get the most out of and make your Yong Heng last a bit longer scroll down.
https://www.airgunnation.com/topic/compressor-tips/#post-837789
https://www.airgunnation.com/topic/compressor-tips/#post-837789
Upvote 0
The container below has the (mineral) cooling water, black circulation pump inside. The circulation pump, a spot light, and the compressor power supply are all plugged into a simple 3-way power splitter. Flipping its switch activates the water circulation and illumination before the compressor itself is switched on.
The black Airmega is the oil-water separator, 25 bucks from Aliexpress. It came with a desiccant and carbon filter inside. I connected the smaller filter unit that came with the compressor to the Airmega with a high pressure hose. The gun fill ports are attached to that smaller filter.
My main advice: put in hydraulic oil, bleed slowly before switching off, and don't let it run for more than a few minutes at a time -- should be plenty to fill yar gun. Open up the filter and let the media dry for a day after a week of use.
Upvote 0