hello guys can some one tell me what thread sizes are on this fx part 
i think the male on right side that fits uargan is m12x1.0 but i not 100% shure
need to know thread pitch on a fx adapter found
- Thread starter gizmo1974
- Start date
There are two different thread adapters for Impact/Maveric/M3. The thread size is the same but not the valve inside to open/close the pressure. This is because one of the tree doesn't have a pre-Reg built in but a separate add-on.
Upvote 0
I GOT YA I SEEN ON THE M3 IT USED A LARGER HOLE THAN 12M MY UARGAN HOLE IS M12X1.0 IS WHAT I WAS TOLD I WOULD LIKE TO KNOW WHAT SIZE THREAD PITCH IS ON THE FX ADAPTER PART THAT SCREWS IN TO ACTION WATCHED VIDEO OF ERNEST REMOVEING IT HE STATED IT WAS 12MM BUT NOT WHAT THREAD PITCH M12 HAS LIKE 4 DIFRENT PITCHES 1.0 1.25 1.5 1.75
Upvote 0
i think i got this figured out the fx part is m12x1.0 and the uargan threads post to be m12x1.0 if this workes i going to screw in the fax parts then use a small bottle with fx check valve if ever thing goes good this will let me run any tank with m18x1.5 threads on my uargan cause agt wount sell any dam tanks i wish agt was like fx
Upvote 0
Anybody know the threads for a seneca aspen? M16x1.5 or m16x1.0? Anybody make a female adapter for ASA screw in using a regulated bottle?
Upvote 0