These instructions leave a lot unanswered instructions. Such as how to degas the system to install a gauge on the plentum Or,change to another size plentum? For the newbie I would think that this should be included. Yes there will be UT videos but why not have them in the instruction manual? After all first thing the manual says is to determine what the regulator and hammer spring settings are. That means you got to know how to degas the plentum to install a gauge and don’t you need to degas the tank first? Nothing stated in the owners manual Except do not disassemble this rifle. Piss poor manual FX.
Proper tuning requires the know-how of what one adjustment does in relationto another and should be performed by a trained specialist.
Warnings• Never attempt to disassemble this rifle.• Never fire the rifle when it is empty of air or when air cylinder is removed.• Never point the rifle at anyone or allow anyone to point a rifle at you.• Treat every rifle as if it is loaded even if you know it is not loaded.• Always carry the rifle so that the direction of the muzzle is under control, even if you stumble.• Always be sure of your target and what lies behind it before firing your rifle.• Never leave a loaded rifle unattended.• Beware of targets that tend to cause ricochets.• It is recommended that eye protection is worn.• Always use caution when operating this rifle.• Learn and obey the laws in your location.• Be responsible in your use of this rifle.• Never fill the rifle with anything else other than regular air.• Never ever fire the rifle below set regulator pressure.• If equipped with a carbon-fiber air tank: inspect according to the instructions on the tank.• Never leave the rifle with ammunition in the bore/barrel.• Do not attempt to remove or disassemble the barrel system (separate manual).• Barrel runs thru a pressurized tube and faulty dismantling can cause seriousdamage.• Failure to obey these instructions could result in personal injury or damageto the gun!
7.5 Hammer-spring tension adjusterThe Hammer-spring tension might need adjustment if you need to tunethe power and accuracy.NOTE – The rifle must be un-cocked when you turn the adjuster.High spring tension gives more power but uses more air.NOTE – for best results the hammer tension needs to work in coordinatedeffort with the appropriate regulator pressure as described further insection 8.1.
Upvote 0