Hello Gunners!
I just joined the Nation and wanted to say hello from NC. I recently acquired an Artemis P15 and noticed a potential problem with the manometer. It appears that the pressure indicator is not properly centered on the needle. When I began airing up the rifle I noticed an indentation on the paper, where the needle was resting on zero during transport. I didn't think much of it at first, but the more air I put into the gun the more noticeable it is that its misaligned. So here are a couple of questions.
Can the manometer be removed from the air cylinder, taken apart and the problem corrected?
Can a replacement manometer be ordered and installed? Any suggestions on suppliers?
Can I use the pressure gage on my pump to determine correct pressure in the cylinder?
I appreciate any feedback you can offer.
Thanks 4nash
I just joined the Nation and wanted to say hello from NC. I recently acquired an Artemis P15 and noticed a potential problem with the manometer. It appears that the pressure indicator is not properly centered on the needle. When I began airing up the rifle I noticed an indentation on the paper, where the needle was resting on zero during transport. I didn't think much of it at first, but the more air I put into the gun the more noticeable it is that its misaligned. So here are a couple of questions.
Can the manometer be removed from the air cylinder, taken apart and the problem corrected?
Can a replacement manometer be ordered and installed? Any suggestions on suppliers?
Can I use the pressure gage on my pump to determine correct pressure in the cylinder?
I appreciate any feedback you can offer.
Thanks 4nash