New VEVOR Twin Fan 4500 arrives tomorrow - Hoping is Good

[RadarMan]

Hello All, Some detailed and pretty complimentary reviews here have sealed my decision to order a Vevor 4500 Dual-Fan compressor last week. Was a struggle between this unit and the more expensive CS4, but those appear to be all Out of Stock. Hopefully the $300+ Savings won’t mean I only get 5 fills out of the Vevor.

I am optimistic because I am quite Mechanically and “Machinery Caring” Inclined.

I’Ii keep you guys updated on how this little Howling Monster does for me. Steve

 

[Scotty1]

I‘ll keep my fingers crossed for you.

 

[RadarMan]

Pretty good so far. I took the cowling off before I plugged it in the first time to see that all was tight and looking good with machine Inside orange shell. Check. Noticed that some of the cable harnesses were sealed with silicone caulking adhesive were plugged into boards and switches. Better than I would think.

Ran it a few times No-Load and then some ramp ups with dead head in place for “Break-In”. All good to 3,000 psi. Was leaving a few minutes of fan cool-down after pressure cycles. No noticeable increase in air temp venting from enclosure. Those 2 little fans are moving a Lot of air.

Today ran it direct into Vulcan 3 with 580cc bottle. It took exactly 10 minutes to go from 150 Bar to 300 Bar. I can live with that easy if not having to deal with those darn Dive Shops.

Temp started at 25 C and after full 10 min. Only up to 36 C. Not bad So far. We‘ll see how things go from here.