Newest Generation - FX Crown Mk II .25

[Milf Dots]

So..I just purchased a FX Crown Mk II and i removed the Rear power adjuster (which has a different type of font on it, its much smaller) and I did not see any springs at all, but the 2 ball bearings were present, did I lose these springs in the process? or are these springs no longer installed in the newest generation of Crown Mk II's? Does anyone know or have any idea? Any help would be greatly appreciated! (The first image is my rifle with the new style power adjuster, and the second picture is the original style.

 

[TMH]

Regardless of the markings & graduations on the hammer spring pre-load wheel, it is held in place/allowed to move via a spring loaded ball detent system.

So yes, there are supposed to be springs under the balls.

Hopefully you just didn't see them on your gun - they aren't very visible when they are down in their holes. Did you try a dental pick or other small instrument (tiny hex key) to try and pull them up and make sure they aren't really there?

 

[pesty3782]

And if you lost them order extra springs and extra ball bearings ...Don't ask how I know

Tony P.

 

[2D1C]

^^^^^^^^^^ what he? said

 

[hawkeye69]

A magnet works well for removing the bearings and the springs without losing them.

 

[Keyman62421]

When I decide to disassemble one of the jigsaw guns, I lay out a sheet of freezer (previously call butcher) paper. BIG WHITE working surface . Magnet laying near where I'm working to catch or keep parts close by!

 

[Milf Dots]

So, they are there! I do see them in the holes!! Thank you guys