Also, I had to move the inner trigger guard on the right side out a bit more (~.5 mm) as it wasn't stopping the safety pin, and therefore, not working properly.I appreciate that, I'll email about the new file! I did run into a sear engagement issue, my fix was to move the sear pin hole slightly higher which allowed it to engage properly and got me a bit more stage-1 pull. I also modified the front end so I could fit my preferred clamp-on handgrip and angled to print things as seen here:
It still needs supports, but I felt better about printing at an angle for strength.
Other changes include moving the grip position forward to accommodate my smaller hand and changing the back end to fold:
Anyway, sorry about the derail! Making things sure is fun.
Upvote 0