Umarex Notos picatinny rails not aligned

[Floridaman2005]

Was looking at the Notos today getting ready to mount a scope and noticed that the front pic rail section and rear pic rail section are not properly aligned. I think if I torqued the scope to the mounts it may damage the scope or be out of alignment.

From people with Notos experience, is there a way to align the rear rail to the front or am I better off getting a cantilever mount that I can span the gap with? Thanks

 

[Avator]

Mine are good to go.. I don't think I've heard this from anyone else either.

 

[stateofmisery]

Pulled out my Notos and straight edge and checked, straight as can be. Don't know how you could adjust them. Your suggestion of a cantilever mount would be your best bet. Mark

 

[Floridaman2005]

Pulled out my Notos and straight edge and checked, straight as can be. Don't know how you could adjust them. Your suggestion of a cantilever mount would be your best bet. Mark

Yeah it have it apart right now in preparation of a plenum install tomorrow but noticed that my back rail section and front rail section are definitely not straight. I see 2 allen screws in the top of the rear section but didn’t know if they give any adjustment to the rear picatinny rail. Definitely does not align with a straight edge. Not off by too much, but not close enough to feel comfortable tightening a scope to it.

 

[Perle]

For the rear mount I’ve found that if you don’t mount dead center ( the center pic slot ) it doesn’t align.

 

[Floridaman2005]

Simple fix. The rear picatinny mount section is held in place by two allen screws. Loosen up both of those screws and the rear pic rail becomes loose from the receiver and can be moved around until it is perfectly square. Kind of what I assumed when looking at it, but haven’t messed with it until today.

 

[stateofmisery]

Simple fix. The rear picatinny mount section is held in place by two allen screws. Loosen up both of those screws and the rear pic rail becomes loose from the receiver and can be moved around until it is perfectly square. Kind of what I assumed when looking at it, but haven’t messed with it until today.

Glad to hear you got it lined out. I realy like my notos enjoy it. Mark

 

[Floridaman2005]

Glad to hear you got it lined out. I realy like my notos enjoy it. Mark

I just installed my CRC Precision plenum. Made a big difference! Going to make a post on it. Very impressed so far. Haven’t been able to FPS test yet because my FX chronograph doesn’t like my Notos I guess. Awesome mod!