OUCH! I knocked my gun off the bench.

[Dingfelder]

Talking conical on the end like the scraped one pictured. No clearance necessary.

OH I see the confusion. That LDC with the scrape is mounted to his gun permanently with epoxy or locktite if this clears the air.

No no, you're right, my bad. Donny recommended a cone on the part of my moderator needed to clear the air cylinder on my Prod, so I wouldn't scrape up the shroud. Wasn't quite big enough, but you're talking about the opposite end -- yikes, sorry. Wasn't thinking for a moment. I misunderstood somehow. Sorry to be misleading.

 

[elh0102]

The silencer in your picture that you ordered from the UK appears to be the same Weihrauch brand silencer that is on my HW100 K rifle, and it works very well. I have read a few comparison reviews in which it ranked very high. The one on your BP might be similar internally, never seen one. 

 

[dcw]

I knocked my RX 1 off my bench and bent the barrel upward so much I had to send it out to be straightened professionally 

 

[noexcuse4you]

There are two types of air gunners... those that have knocked their gun off the bench, and those that will knock their gun off the bench.

 

[AirgunnerSC]

Happened to me last week. Decided to shoot my gauntlet and knocked it off the bench scarring the scope and of course POI was off. Had not happened in a long time and yes it was completely my fault. Just wasn't paying attention when I got up to examine my groups.

 

[nicecue]

Ouch, but that looks like it hurt you more than the gun. Not fun

 

[cea1960]

First time shooting the HW the other day and noticed the groups were horrible. Today a very fine snow was falling and indicated absolutely no wind. What better day to see what's going on with the gun. Groups would be tight, then shift and tight in that spot until they shifted again and grouped. While checking the scope mount screws I noticed a crack in the stock and realized the impact was more than I first thought. I took off the Discovery and installed the Arken and no poi shift and all the groups are tight at 48 yards. The scope is now suspect and the stock will go in my shop for gluing.