I have a city lot so shooting outside is not an option. I do shoot paper targets in my basement at 10 meters.
I was looking at the Sig Sauer Quad metal target trap for indoor use in the basement.
Has anyone had any experience with this pellet trap? And if so, I have a few questions on this pellet trap.
Would this pellet trap work well at 10 meters?
Do the pellets ricochet out or bounce back out of the trap often when hitting the target?
How often do the targets need to be replaced? How long do they last? Do they sell replacements?
Good build quality?
Does the reset function work well?
Thanks!
 
  • Love
Reactions: ThomasT
Just looking at some pictures it looks like thin sheet metal . Unless the backstop part is a lot thicker I don't see it lasting .

Maybe if you only shoot sub400fps stuff ... Maybe

Or if you do have it and the back stop gets swiss cheesed have a metal shop /votec/?? That can cut you a bolt in piece of 3/16min plate. Or just donate to a school metal shop and have one build with 3/16" steel and probably last a lifetime vs that sheet metal one

Just seems a lot of them traps like your looking at is basically red Ryder grade ( opinion)
 
I use this one. Not sure if it meets your needs.

 
Just build one.
one piece of 1”x4”x8”’ lumber.
8 pieces 12” long.
four for the sides, four for the back.
put some duct seal (It looks like C4 explosive in the electrical section of hardware store).
about 10 pounds of it.
put a bull clip or two on the top to hold your target.
I added a lower box to catch the occasional fall out:

IMG_2824.jpeg
 
  • Like
Reactions: drpietrzak
Maybe I should have added that I make my paper shooting back stops using shipping boxes filled with old blue jeans and it works very well.
I reason I was looking at this pellet trap, it would give me another option for target shooting in the basement, instead of just shooting at paper targets all the time. This would be an alternative to shooting paper all the time, that is why I am considering this trap.
 
Last edited:
Just have a look right here on Airgun Nation. Large plastic tote filled with rubber garden mulch with a target sized window cut out in the lid. I used scrap carpet glued inside the lid for the target surface. Line the bottom with 1/2" plywood for just in case. I have no doubt mine would hold up to .22 LR. Metal pellet traps are loud on impact. Our home page has a resource center with plans. About 20 bucks to build a nice quiet effective pellet trap. Will take 2-3 bags of rubber mulch 7 bucks a bag plus the tote. Got rather angry a few days ago, I went to my club for pistol practice. The target plywood was really shot up so one of my fellow members put their targets on the 4 X 4 supports and shot the S out of the 4 X 4's. That jerk is a member, apparently. They made the repair cost 100 bucks rather than 25. What is wrong with people today to destroy equipment at "their" club??? Had another clown shoot our very costly bullet trap with .50 AP they aimed to do maximum damage to the bullet trap. Why??
 
Last edited:
I have a city lot so shooting outside is not an option. I do shoot paper targets in my basement at 10 meters.
I was looking at the Sig Sauer Quad metal target trap for indoor use in the basement.
Has anyone had any experience with this pellet trap? And if so, I have a few questions on this pellet trap.
Would this pellet trap work well at 10 meters?
Do the pellets ricochet out or bounce back out of the trap often when hitting the target?
How often do the targets need to be replaced? How long do they last? Do they sell replacements?
Good build quality?
Does the reset function work well?
Thanks!
Hello @flagger

I have two of the Big Bang Pellet Traps and have shot over 6,000 rounds through them over the last couple of years. Not sure if Pete @Pellet trap man has any left in stock.

ThomasT
003.jpg
Big Bang Pellet Trap 23.26.jpg
 
  • Like
Reactions: Bramezy and Rondo
If you are really cheap, go to the post office and get some priority mail boxes and fill with rubber mulch.
as the boxes get shot up use duct tape to seal the holes.
hint: you can shoot both sides.
when the tape doesn’t work anymore (about 5000 shots), dump everything into a large tub of water.
the lead will sink to the bottom and can be re-cycled (give it to your Black Powder friends) and the rubber will float to the top where it can be used indefinitely!!!
 
  • Like
Reactions: rsfrid
Last edited:
Just have a look right here on Airgun Nation. Large plastic tote filled with rubber garden mulch with a target sized window cut out in the lid. I used scrap carpet glued inside the lid for the target surface. Line the bottom with 1/2" plywood for just in case. I have no doubt mine would hold up to .22 LR. Metal pellet traps are loud on impact. Our home page has a resource center with plans. About 20 bucks to build a nice quiet effective pellet trap. Will take 2-3 bags of rubber mulch 7 bucks a bag plus the tote. Got rather angry a few days ago, I went to my club for pistol practice. The target plywood was really shot up so one of my fellow members put their targets on the 4 X 4 supports and shot the S out of the 4 X 4's. That jerk is a member, apparently. They made the repair cost 100 bucks rather than 25. What is wrong with people today to destroy equipment at "their" club??? Had another clown shoot our very costly bullet trap with .50 AP they aimed to do maximum damage to the bullet trap. Why??

IMG_0232.jpeg


IMG_0229.jpeg


IMG_0228.jpeg
 
  • Like
Reactions: Ricklin
This is what I have used for years. Built like a tank and rated up to 44 mag.

The storage container linked above costs less than the shipping cost of this bullet trap. Very nice unit for those that can shoot PB in the backyard, I'd guess the majority here are like me and don't need to go this far. I'm certain my rubber mulch box would easily handle .22 PB. Very nice for those that could use it. We built a massive trap for our rifle range, some bozo snuck in and shot it up with .50 BMG AP rounds.
 
  • Like
Reactions: BABz58