I cut a small batch of Prophet 3 bag rider adapter plates from 5mm carbon fiber so that P3 owners can still use the P1/P2 bag rider tube.. They are 1mm chamfered on both sides for safety & comfort.
I'm going to call Tony @ Talon Tunes tomorrow to see if he wants the extras I cut. If anybody wants one immediately I just need to cover my cost ($10)+ shipping. I only have screws for 2 plates. You will need M4 x .7 thread in 15mm length. Hardware stores like Ace only carry them in 12mm and 16mm length. The 12mm is to short and the 16mm is 1mm too long. I had to grind about .75mm off the end to get the screws to tighten down.
I only have 8x so the first 8 to reply to this thread will get one.
I'm going to call Tony @ Talon Tunes tomorrow to see if he wants the extras I cut. If anybody wants one immediately I just need to cover my cost ($10)+ shipping. I only have screws for 2 plates. You will need M4 x .7 thread in 15mm length. Hardware stores like Ace only carry them in 12mm and 16mm length. The 12mm is to short and the 16mm is 1mm too long. I had to grind about .75mm off the end to get the screws to tighten down.
I only have 8x so the first 8 to reply to this thread will get one.
| Adapter Plate and Bag Rider Installed | Plate follows the rear block shape with easier HST wheel access and maintains access to the bleed screw. |
Adapter plate is mounted using the existing butt plate | |
