Looking for some help, my puncher breaker air tank leaks around the burst disk. Is it possible to get and replace the burst disk screw? I rounded out mine. Emailed Kral as of yet received no response.
Tuning Puncher breaker burst disk leaks
- Thread starter firefrank125
- Start date
Kral is a wholesale Manufacturer and doesn't handle customer service. That falls on the Importer/Retailer. Where did you buy it and where are you located? I can probably help you out.
Upvote 0
Thanks for your reply, I purchased it from Pyramid Air like 2 years ago. I called them and they referred me to CS at Air Venturi. Though concerned, it was suggested to contact an air gun parts business in England. I’m located in Connecticut, any ideas?
Thanks again
frank
Thanks again
frank
Upvote 0
Let me check my parts bin I might have a set. If you get a star bit for a screw driver just larger that the original hex head you can tap it it and it will bite for you to tighten or loosen until the replacement gets there.
Upvote 0
Just dawned on me, is this Troy from Annihilator Airguns? If so, I subscribed to your channel when I got the Puncher. Great videos, very interesting.
Thanks
frank
Thanks
frank
Upvote 0
