I'm trying to fill my new FX Impact M4 Sniper. The parts list includes a dust cap and a quick disconnect female. I didn't receive either of these parts.
Did FX stop including these items with the new M4's?
My compressor disconnect is about 19mm diameter but the recess in the gun is only about 17mm.
What connectors are you guys using to fill your Impact M4?
Thanks
I found a work around and I'm glad that I did. I can take off the trigger guard and then have plenty of access to the male disconnect fitting. All four of the trigger guard's screws were loose out of the box which is why I'm glad I checked them. Now I'll have to go over the whole gun to see if everything is tight - bummer for such an expensive gun.
I'm using a cheap compressor to fill with and it worked well. It can also work off a car battery and comes with lots of extra filters. 12 minutes to go from 117-250 bar without a hitch. Still got my fingers crossed though.
Did FX stop including these items with the new M4's?
My compressor disconnect is about 19mm diameter but the recess in the gun is only about 17mm.
What connectors are you guys using to fill your Impact M4?
Thanks
I found a work around and I'm glad that I did. I can take off the trigger guard and then have plenty of access to the male disconnect fitting. All four of the trigger guard's screws were loose out of the box which is why I'm glad I checked them. Now I'll have to go over the whole gun to see if everything is tight - bummer for such an expensive gun.
I'm using a cheap compressor to fill with and it worked well. It can also work off a car battery and comes with lots of extra filters. 12 minutes to go from 117-250 bar without a hitch. Still got my fingers crossed though.
Last edited:
