RAW Rapid RAW HM1000X post takeover by Airforce. Need technical help

[mubhaur]

Hi friends,

I am working on making a plenum for RAW HM1000X post takeover model that could be attached between the block and the regulator.

The RAW guns that I own are pre takeover models.

Later RAW has increased the dia of the regulator to enlarge the plenum a bit as shown in following picture.

For the above ( post takeover) regulator model I need following specs.

The length and dia of the regulator cavity highlighted in red colour in following picture which is smooth without threads.

2nd is the size of O ring on the regulator as shown in the following pic with red colour .

This will be a great favour to me.

Regards,

Bhaur

 

[Airgunmann]

Thought it would give thread size on huma size but it's just approximate thread size

 

[mubhaur]

Got the required information from a friend.
Thank you friends

 

[Airgunmann]

Good to know