Hello all,I own a RAW .30 caliber air rifle. It’s a beauty with excellent fit & finish, and very accurate. When bench shooting I prefer using a single shot loading tray. But the one that RAW sells is not to my liking. I have big hands and big fingers and dropping a pellet onto the tray in the correct loading position can sometimes be a "hit & miss" proposition.While searching the various air gun forums on the Internet I cam across a thread that discussed someone’s new bipod holder that was made by just using a 3-D printer. To make a long story short, I Emailed the owner of the 3-D printer and he agreed to try and make me a NEW DESIGNED single shot loading tray. After many Emails back and forth to discuss design and correct measurements I received my first NEW single shot loading tray for my .30 caliber RAW. Keep in mind that this single shot loading tray was made by using a 3-D printer. So far, it has worked as expected. I load a pellet with the tray in the open position, close it, close my pellet probe, and fire. Re-open the tray and load again, and so on. So much nicer to shoot my RAW using this tray. Here are a few photos of the tray.
