If you know of an Edgun repair or service location in the USA that is neither Edgun West nor affiliated with them, please post it here. Thanks.
EDgun Recommendations for Edgun Repairs or Service in USA
- Thread starter RobertNoPest
- Start date
I am so thankful for these recommendations. I am taking notes! These are great air rifles, but seem to have very delicate mechanisms. And I am no gunsmith . . .
Upvote 0
I/we own four Edguns, three Leshiy 2s (.177, .22, and .30) and a Lelya .22. It has been a journey getting them working properly, from new. Popping the pests, and all the best.
Upvote 0
One of the Leshiy 2s is apparently making a little air hiss sound before the trigger actuates. Is that user error?
Upvote 0
Yes, you don't squeeze the L2 trigger as you would with stage 1/2, but tap it as the AK and no follow up just let it back. After some training you will see a better performance.
Upvote 0
Great advice, which I passed along. Having to retrain our brains, as we are used to two-stage triggers. Thanks!
edited for grammar
Upvote 0
I just live with it and keep my trigger pull the way I'd normally do it. I have a pretty good "compressed surprise break", but I still hear the hiss. It doesn't seem to negatively affect the shot - just wastes a little air.
GsT
Upvote 0
That is good to know, thanks for that info. I was hoping that the regulator takes care of the "dose" of air the pellet receives, but wasn't certain. Cheers.
Upvote 0
I wasn’t aware EDgun was making the Marauder now…
Short of sending it to Benjamin, Airgun Revisions is probably your best bet.
Upvote 0
No... what you asking is two Regs, one for the pellet and second for indexing gizmo.
The L2 has a single Reg with relatively large plenum volume.
To propel the projectile there is an amount of air volume needed, and approximately 60 bars needed as a minimum to make the indexing work.
From the amount of air the jets playing the Dwell. Smaller hole jets keeps the Valve open longer and larger jets shots the Valve faster.
Not the jets hole ID is a game changer, but you need to do some simple math. The hole ID to convert to "area" where to air flows through.
Something like this:
When you start calculating with "area" you will realize, that for example instead of two 04 jets has smaller area then one 08 jet... or two 07 jets is less then a half then one 1.4 jet....
And you go from there
Upvote 0
Just a comment: I appreciate this thread! Mailing Edgun products to Spain absolutely works (purchases are easy and less expensive than in the USA), but sending a rifle needing servicing all the way to Europe seems a bit much. I have done that with wristwatches, but they are small.
We are shooters only, with no interest in servicing or repair of such tools. Ballistol and common sense are our guides . . .
We are shooters only, with no interest in servicing or repair of such tools. Ballistol and common sense are our guides . . .
Upvote 0