Tuning Royale 400 Hammer Guide Reassembly

[napairgunner]

I removed the hammer adjustor from my Royale 400 which was already loosed by mistake (first time working on the gun) it looks like the spring fit's into a guide and the guide is now loose in the bloc my question is what is the proper alignment of the hammer spring guide so I can put tension back on the spring. I didn't see any YT videos about this. 

Thanks,

Mark

 

[jwrabbit123]

HI please show a picture of what you mean >??? it is a real basic set up I own one , here is a diagram on how to assemble it , past number D 1 to D4 is all their is and it shows order and way it goes , what is it you mean ? what speeds are you getting since you messed with it ??? you need to show images or be more specific , like I am only getting 500fps or it wont cock since I took it apart

LOU

View attachment royale-1.1643618100.pdf

 

[elh0102]

It floats when not cocked, will always be loose.

 

[Glem.Chally]

It floats when not cocked, will always be loose.

 

[napairgunner]

Here's the picture I was just concerned the sleeve should not be loose. I am not feeling much spring compression I re-assemble is that normal? How far in to you suggest I put the hammer screw? Thanks for all the help.

 

[Glem.Chally]

That sleeve is the inside of the hollow hammer. Screw the hammer spring tensioner (5mm cap nut thing) all the way in then back it off like 3 full rotations. 

FX have a "free floating hammer" so there's only tension on it when the gun is cocked. 

Have you looked at the schematic?

View attachment royale-1.1643664680.pdf

 

[napairgunner]

Thanks for the help I will test tomorrow and report back.