Hello everyone
I have a problem with my new (less than 70 shots) p3 .25 :
started shooting this morning, 3 shots perfectly fine as usual. shot again an hour or so later and shots were lower power, landing 25cm low at 40m.
Adjusted power wheel up 2 clicks and down 2 clicks to where it was, shot ok again for 3 or 4 shots, then the sear would not engage properly 4-5 times in a magazine, even resulting in 3 times firing (low power ) when pushing the cocking lever forward, not touching the trigger. So it fired by itsself. twice the pellet did not leave the barrel. Then random in the magazine it would be hard to cock and shoot low power,… no consistency in the problem. At this pricepoint I expected something else… my 8 year old edgun ever missed a beat
tried adjusting hammer spring down, problem persists. Every once or twice it won’t cock…Any idea what is going on? (Did not touch the hammer spring adjustment from store (2 clicks from 0), 130 bar, did not touch trigger adjustments)
edit: opened the side plate up, cannot see anything wrong other than the cocking linkage rubbing on something (Where it enters the rear block) Tried to replicate the problem but cocked properly every single time (did not shoot because at home), did not have magazine in or pellets in the barrel.
does anyone know what is going on? I’m trying her again on saturday. Was thinking the oils or grease were impacted by the cold? (Not that cold here, 6 degrees celsius…
I have a problem with my new (less than 70 shots) p3 .25 :
started shooting this morning, 3 shots perfectly fine as usual. shot again an hour or so later and shots were lower power, landing 25cm low at 40m.
Adjusted power wheel up 2 clicks and down 2 clicks to where it was, shot ok again for 3 or 4 shots, then the sear would not engage properly 4-5 times in a magazine, even resulting in 3 times firing (low power ) when pushing the cocking lever forward, not touching the trigger. So it fired by itsself. twice the pellet did not leave the barrel. Then random in the magazine it would be hard to cock and shoot low power,… no consistency in the problem. At this pricepoint I expected something else… my 8 year old edgun ever missed a beat
tried adjusting hammer spring down, problem persists. Every once or twice it won’t cock…Any idea what is going on? (Did not touch the hammer spring adjustment from store (2 clicks from 0), 130 bar, did not touch trigger adjustments)
edit: opened the side plate up, cannot see anything wrong other than the cocking linkage rubbing on something (Where it enters the rear block) Tried to replicate the problem but cocked properly every single time (did not shoot because at home), did not have magazine in or pellets in the barrel.
does anyone know what is going on? I’m trying her again on saturday. Was thinking the oils or grease were impacted by the cold? (Not that cold here, 6 degrees celsius…
