Just installed on my M3 impact in the same location as the factory 2nd reg gauge, gassed up and don’t get no bar reading, I used the rubber washer that came with it but the factory wika gauge didn’t have nothing but a drop of loctite, did I do something wrong
Sekhmet gauge
- Thread starter 20Satan
- Start date
Don’t know about gasket that came with it. Same happened with mine. Silicon lube stock gasket and reinstall. Small small drop of favorite thread locker. Install gauge hand tight…snug. Verify you get a reading and are happy with display angle.
There is not a lot of room in there. Rubber (at least stock) gasket crushes and covers gauge and gun holes very easily.
There is not a lot of room in there. Rubber (at least stock) gasket crushes and covers gauge and gun holes very easily.
Upvote 0
Might be screwed in too much. I would degas and then unscrew the Sekhmet some and see what you get.
Upvote 0
I just degassed the gun took off the washer/oring that came with it and it still reads 0, only put it on hand tite with little drop of loctite
Upvote 0
Do not need loctite.. O ring is all you need to seal.. Try backing out the gauge to see if you get a reading.. If not try the charging cord, as sometimes it will wake it up.. One other thing to try is resetting the gauge according to the instructions..
Upvote 0