Seneca Dragon Claw .50 Barrel Thread Size

[sonnysan]

I've been told for some time that these guns do not have standard threads, and sometimes nothing will screw into them. Well I've come across a Dragon Claw with
.659x18 threads. Yes, that is between a 5/8x18 and 3/4x16. I've also tried metric to no avail. The threads are definitely x18.
Does anybody know the thread size on the female end of the A47?

Sam Yang .50 cal Dragon Claw A47 – DonnyFL

Sam Yangs are known to output some crazy power. This adapter with M18x1 threads will allow you to screw on the Emperor v3. You might have need the Extender as well if Silence is a Priority!

donnyfl.com

I've tried emailing Donny, but no reply. Not surprised, as they probably laid off the machinist.

Has anyone put on a mod on this gun and could not do so? Thank you.

 

[Enkey]

Hi
Sam yang threads usually do not exist you have to find the thread pitch and diameter you need a machinist to make it.
Regards
Enkey

 

[DesertSilver]

Get a hold of Niel Cleg. Not sure if I'm spelling his name right but he made the 1 for my Sumatra and I'm sure he's made them for other Korean air rifles. Without the ldc my Sumatra is louder than a .22 long rifle PB. With it it's very quiet.

Yeah, I did spell it wrong.

Neil Clague Shrouds and LDC's

 

[sonnysan]

Neil is a great guy and he warned me about Dragon Claws with bastard threads. Basically threads like this need to be done by hand. So you are looking at a $250 adapter. The Donny A47 is a more attractive option, but if it is a 5/8x18 or 16.5x1.5mm the diameter is too small. I did reach out to another Dragon Claw owner, and he is on the same road as me. Perhaps Seneca doesn't want these guns to have a mod fitted on them in the first place.

 

[MI_Yeti]

Neil is a great guy and he warned me about Dragon Claws with bastard threads. Basically threads like this need to be done by hand. So you are looking at a $250 adapter. The Donny A47 is a more attractive option, but if it is a 5/8x18 or 16.5x1.5mm the diameter is too small. I did reach out to another Dragon Claw owner, and he is on the same road as me. Perhaps Seneca doesn't want these guns to have a mod fitted on them in the first place.

Samyang, the oem for the dragon claw dose make and sell a moderator for them. Just not in the US. http://airrifle.co.kr/bbs/board.php?bo_table=sub02_04&wr_id=4

 

[sonnysan]

Thank you for the link. I actually bought the small OEM 10mmx1 LDC years before I owned any Careers/Sumatras, etc. I didn't know it was OEM, but it fit perfectly on a Career .177 after I realized it was needed after firing one round. Even the .177 sounds like a high powered rifle going off.