For sale in like new condition, in box, this slug mold:
noebulletmolds.com It comes with the 3 sets of pins for a deep hollow point, shallow and flat nose tip.
It saw one round of casting tin metal slugs, so a relatively low heat (~500 F, 260C), with beeswax flux. It cast beautiful slugs, but they are too big for my particular barrel. This casts a 0.251 slug, so it would be a good choice for a slightly oversize 25 caliber barrel (one that your .249 or .250 slug "falls" into and isn't accurate; Pyramyd says Hubens and Leshiys in particular might enjoy larger slugs), for re-sizing to a smaller bore after casting, or perhaps for a very soft lead.
$100, plus your choice of shipping, OBO.
EDIT: I'd be happy to send you a few cast tin slugs if you want to see how they fit your barrel.
251-39-RF-CH4 2 Cavity RG2 PB | NOE Bullet Moulds
noebulletmolds.com It saw one round of casting tin metal slugs, so a relatively low heat (~500 F, 260C), with beeswax flux. It cast beautiful slugs, but they are too big for my particular barrel. This casts a 0.251 slug, so it would be a good choice for a slightly oversize 25 caliber barrel (one that your .249 or .250 slug "falls" into and isn't accurate; Pyramyd says Hubens and Leshiys in particular might enjoy larger slugs), for re-sizing to a smaller bore after casting, or perhaps for a very soft lead.
$100, plus your choice of shipping, OBO.
EDIT: I'd be happy to send you a few cast tin slugs if you want to see how they fit your barrel.
Last edited:
