Picked up 2 more guns and need to make room in the rack so these 2 need to go.
Gamo Urban .22 with CF shroud. I 3D printed the bushing for this. It is much quieter then the big pickle that was on there. The barrel was shortened about an inch and re-crowned when I put the shroud on. Shoots the JSB 13.43 at approx 900fps for 25 shots. One hole at 25yds, haven't shot any further. Comes with 2 mags and fill probe. Original owner polished the bolt handle and drilled the stock for adjustments without removing it. Not sure what, if anything was done to it, this is from my visual inspection. I picked up the gun used in a trade about a year ago. I also did the camo on the stock with Rust Oleum Camouflage paint. (Scope and rings not included)
$225 plus shipping from 21009
Qb79 (.177) with 13ci Ninja bottle regged at 1350PSI. Tank block has been pinned to tube to allow pressures above 1100 on the reg. I did all of the "standard" mods to this gun. (valve, trigger, delrin poppet, cock on open, SSG, etc) I did it about 3 years ago so don't remember everything. The shrink tubing on the RWS compensator makes it backyard friendly. It loves the JSB 10.34 and is tuned to shoot them at approx 875fps. Haven't run a full string but has to be 90 or more.
$175 plus shipping from 21009
Gamo Urban .22 with CF shroud. I 3D printed the bushing for this. It is much quieter then the big pickle that was on there. The barrel was shortened about an inch and re-crowned when I put the shroud on. Shoots the JSB 13.43 at approx 900fps for 25 shots. One hole at 25yds, haven't shot any further. Comes with 2 mags and fill probe. Original owner polished the bolt handle and drilled the stock for adjustments without removing it. Not sure what, if anything was done to it, this is from my visual inspection. I picked up the gun used in a trade about a year ago. I also did the camo on the stock with Rust Oleum Camouflage paint. (Scope and rings not included)
$225 plus shipping from 21009
Qb79 (.177) with 13ci Ninja bottle regged at 1350PSI. Tank block has been pinned to tube to allow pressures above 1100 on the reg. I did all of the "standard" mods to this gun. (valve, trigger, delrin poppet, cock on open, SSG, etc) I did it about 3 years ago so don't remember everything. The shrink tubing on the RWS compensator makes it backyard friendly. It loves the JSB 10.34 and is tuned to shoot them at approx 875fps. Haven't run a full string but has to be 90 or more.
$175 plus shipping from 21009