Recently I purchased an LG 110 Field Target rifle from a fellow shooter at a club that I shoot at. My problem is I shoot in the open class an this is a 12 fp gun and I would like to bump it up to 20 fp. From what I have been able to find it seems that the reg is able to be changed by rearranging the belleville washers. Curious if anyone has this information or a source where it can be found.
Steyr LG 110 regulator
- Thread starter 491458
- Start date
From Tom Holland at Field Target Tech on you tube.
Hope this helps
"I have (()) (())|| config and changed it to classic ()()()() || I found it is much better. Very interesting what will say the Phil about new config.
the new regs from Steyr are coming with the (())(()) configuration.
when i stripped it the config was different to what i've seen put up on here () () () () this is what i've seen on here mine is (()) (()) and 2 shims is there any reason for this config on the adjuster screw is just over one turn from closed."
Hope this helps
"I have (()) (())|| config and changed it to classic ()()()() || I found it is much better. Very interesting what will say the Phil about new config.
the new regs from Steyr are coming with the (())(()) configuration.
when i stripped it the config was different to what i've seen put up on here () () () () this is what i've seen on here mine is (()) (()) and 2 shims is there any reason for this config on the adjuster screw is just over one turn from closed."
Upvote 0
STEYR LG 110 Regulator advice
Nation, At long last I have finally acquired a Steyr regulator tester. The results of my regulator test were not surprising, in fact, they confirmed my suspicions. I bolted the regulator on the tester, and pressurized it with the air cylinder. It immediately went to 85 BAR (which is the...
www.airgunnation.com Some info here for you to consider.
Upvote 0
Hey Skip, the () () () () w/ 1 or 2 shims, (4 donuts) is the classic 12 FPE configuration....all my Steyrs shooting 12 fpe have that. Over 12 fpe there are at least 2 other configurations I have seen.
Upvote 0
Higher output comes with Stacked pairs )) (( )) (( .... singles are for lower output settings ) ( ) ( ) ( ) (
Upvote 0
Thanks for all the information but I really need the configuration of the 24 joules regulator. Im not that mechanically inclined and I have no way of testing it so I really only want to do it once.
Upvote 0
Motorheads input should be regarded as one step below rules engraved on a stone tablet!
Start there unless you get a factory diagram or set up instructions from Steyr.
Start there unless you get a factory diagram or set up instructions from Steyr.
Upvote 0
Have you watched this video on changing reg stacks?
This will give you the 24J reg set up, and then fine tune with the Steyr power adjuster on the rear. Looks like it should get you pretty darn close to desired results.
Ignore the part about the choke, I believe that only applies to the semi auto rifles.
Last edited:
Upvote 0