Strelock pro error or my fault?

[mubhaur]

When I enter the scope hight of 1.65" in the application and enter the start distance of zero yards and then increase distance by 10 yards difference the result of calculation charts appears to be wrong. It shows zero elevation adjustment at zero range while as the scope hight is set at 1.65" , the elevation adjustment are zero range should be 1.65".

Any one ever faced it? Any solution?

 

[X27]

What did you enter as your zero range for the scope?

 

[mubhaur]

Zero range is 23 yards

 

[SDellinger]

Go shoot you gun and find out what really happens. I did all the Chairgun and Strelock stuff with my FX500 but it was when I did real world shooting that I got real world results. Plus it's a great way to do more shooting. Have fun, Scott

 

[Bullfrog]

It wouldn't be impossible for Strelock to have a glitch. However, I've found that when the program is in error, its always my fault. There are all sorts of variables that can be over looked in the program. I don't know where to tell you to start looking for your specific question. But just as an example, I could never get the target scaling and mildots to perform correctly until I got the focal plain settings correct. There have also been times that incorrect velicities were entered for different enviromental conditions and it took me a while to find the tab where velocities by temperature were entered. Now I just set all my velocities the same regardless as to enviromental conditions.