Airgun Technologies Strong leak Uragan 2

[Urbina]

Hello everyone...

I've had my Uragan 2 for a few months, and everything was going excellent.

But about four weeks ago, air started leaking out of the barrel, slowly, I fired a few shots and it stopped.

But last weekend, I found the tank empty. and when trying to fill it, the leak through the barrel was so strong that it was not possible to raise the pressure in the tank, even when cocking. Any idea what I need to repair or replace? Has anyone else had the same problem?

 

[Kpac]

Hello everyone...

I've had my Uragan 2 for a few months, and everything was going excellent.

But about four weeks ago, air started leaking out of the barrel, slowly, I fired a few shots and it stopped.

But last weekend, I found the tank empty. and when trying to fill it, the leak through the barrel was so strong that it was not possible to raise the pressure in the tank, even when cocking. Any idea what I need to repair or replace? Has anyone else had the same problem?

Its the small o-ring in the block sometimes even the one on side of tran port

 

[imtrigerhapy]

I thought i read somewhere that it could be the valve not seating under low fill rates try from what i read smacking the butt stock with hand while filling with a compressor i believe the post i read stated thise like to be filled with bottles ...but i could be wrong lol and whacking the buttstock if free

 

[WorriedMan]

My Uragan 2 lasted a few months before balanced valve went bad. No leak thru barrel, just started alternating between full power and squib shots. Returned to Krale under warranty where original style balanced valve was replaced with an AGT re-design, no problems since. Unable to fill and leaking thru barrel was caused by broken valve (pictured) in my JTS Airacuda Max, wouldn't be surprised your valve is culprit, as well. WM

 

[maxtrouble]

@WorriedMan - I agree. I had the same issue with a broken valve on my HW44. Would not fill and air poured out of the barrel.

 

[rangur1]

Had a U2 compact with same issue, valve seal went bad or the corrisponding o ring inside the valve, change both.

 

[Macros]

Your gun probably has the gen 1 valve, which has the sealing o-ring for the balance chamber on the valve piston. Just a matter of when it's going to leak. The redesign/gen 2 has the oring in a groove in the balance chamber itself and has no issues anymore.
They'll replace it for you without issues I have no doubt.